- Description
Details
The AKG PCC130 SW is a surfacemounted small cardioid microphone of professional quality. This handsomely styled unit is appropriate for use on the most elegant boardroom table or lectern. Other applications include churches, courtrooms and teleconferencing.
With its small size, the PCC130 SW is less conspicuous on a conference table than comparable mics. Because of its highly directional pickup pattern, the PCC130 SW minimizes background noise and feedback.
The microphone uses the principle of phase coherency achieved by mounting a small-diameter mic capsule very near a boundary. Direct and re- fl ected sound waves arrive at the mic in-phase, and add coherently. This enhances sensitivity, clarity and reach.
Self-contained electronics eliminate the need for an in-line power module. Powered by 12-48V phantom power, the PCC-130 has a low-impedance balanced output which permits long cable runs without hum pickup or high-frequency loss. Included with each PCC-130 is a 15-foot (4.6-m), two-conductor shielded microphone cable with a TA3F connector (mic end) and 3-pin male XLR-type connector (output). Although the standard connector on the microphone is a Switchcraft TB3M, the microphone can be special-ordered with a ¼-inch stereo phone plug on the bottom of the base plate as the PCC130 SW SPP.
Capable of withstanding up to 120 dB SPL without distortion, the PCC130 SW will never overload in practical use. Its electret-condenser capsule provides a wide, smooth frequency response from 50 Hz to 20 kHz. RFI suppression is included. Self-noise is low and sensitivity is very high. A bass-tilt switch allows the user to tailor the low-end response for particular applications.
Permanent mounting is enabled by screw holes in the base. Engineering attention-to-detail has assured years of reliable use from this troublefree microphone.- Features
Features
- Miniature-sized Phase-Coherent Cardioid condenser microphone with programmable membrane switch
- Ideal for boardroom tables, lecterns, churches, courtrooms and teleconferencing
- Small and inconspicuous
- Cardioid pattern reduces background noise and feedback
- Prevents phase interference due to table sound reflections
- Three-position bass-tilt switch
- Type: Phase Coherent Cardioid
- Specification
Type Phase Coherent Cardioid Element Electret condenser Frequency response (typical) 50 Hz to 20,000 Hz at 30 degrees incidence to surface Polar pattern Half-cardioid (cardioid in the hemisphere above the mounting surface) Impedance 150 ohms nominal (85 ohms actual), balanced, (recommended load impedance 1000 ohms or greater) Open circuit sensitivity (typical) 22 mV/Pa (–33 dB re 1 volt/Pa) Power sensitivity –30.5 dB re 1 mW/Pa. EIA rating –125 dBm Equivalent noise level (self-noise) 22 dB SPL typical (0 dB = .0002 dyne/cm2), A-weighted S/N ratio 72 dB at 94 dB SPL Maximum SPL 120 dB SPL produces 3% THD Polarity Positive pressure on the diaphragm produces positive voltage on pin 2 with respect to pin 3 Operating voltage Phantom power, 12 to 48 volts DC on pins 2 and 3 with respect to pin 1 Current drain 6 mA nominal Safe operating temperature range –10° to +50° C, or +14° to +122° F Connector Switchcraft TB3M in model PCC-130. Bottom-mounted ¼-inch stereo phone plug in model PCC130SPP Cable 15 foot with Switchcraft TA3F and A3M connectors. No cable supplied with SPP option Switch Slide switch for bass cut, bass boost, or flat Materials High-impact molded plastic and steel mesh grille Optional accessories PH-1A phantom power supply (single channel, battery or AC adapter powered) Finish Black Dimensions (H x W x D) 0.98" (25 mm) x 2.52" (64 mm) x 3.5" (89 mm) Weight 0.37 lbs (170 g) - Reviews
Write Your Own Review