The ATUC-50INT is an interpretation unit enhancing the ATUC-50 conferencing system with up to three (3) language interpretation. The alphanumeric LED display has 4 buttons where the left-most button selects the choice of the incoming language and the rightmost button selects the choice of outgoing language. The middle two (2) buttons toggle between language select or headphone volume select and control.

There can be up to two (2) ATUC-50INT assigned per language, which enables a total maximum of six (6) ATUC-50INT interpretation units per system. The ATUC-50INT can be placed anywhere in the chain/ring and does not require a proprietary cable run.

The ATUC-50INT features relayed interpretation. This enables the interpreter to choose between listening to the floor (spoken) language or to another interpreted language (Language 1). If there are two (2) ATUC-50INT units per language these can be setup in three different modes:

– Interlock: one unit can override the other unit

– No interlock: no unit can override the other unit while active

– Combined: Both units can be active at the same time

The configuration of all ATUC-50INT interpretation units can be set up using the built-in Web Remote conference management software on the ATUC-50CU Control Unit.

• Interpretation unit for up to three (3) language interpretation
• Alphanumeric LED display with 4 buttons for choosing the incoming and outgoing languages, and adjustment of the headphone output level
• Choice of floor or relayed language as incoming language
• Interlock, no-interlock and combine mode of the interpretation units
• Up to two (2) interpretation units per language
• 24 Bit/48 kHz audio quality
• 3 Pin XLR connector for the ATUC-M43H or ATUC-M58H gooseneck microphones or any 24V phantom powered condenser microphones
• One-directional and bi-directional interpretation function

Spec Sheet

Application Brochure

Manual