- Description
Details
The PL-PLUS is an enhanced version of the PL-8. Its front panel provides a handy display of AC line voltage by means of a 20 LED bargraph meter, reading from 90 to 128 Volts in two-volt steps. The normal range voltages are indicated in green, with moderate and extremely high or low voltages in yellow and red respectively. Note that the LED meter continues to read even when the master switch is off. This was done purposely to allow you to check the voltage before powering up. The LEDs are designed for continuous, ongoing use. They consume little power, just a few cents worth per month, much like a clock.
The PL-PLUS features 15 amp capacity, as well as a more sophisticated RFI filter network with a greatly improved capacity for stopping line noise. This filter is a low-pass type, composed of high-voltage capacitors and an inductor. It passes the low (50 or 60 Hz) line frequency while rejecting high frequencies, with maximum attenuation in the region from 1 to 100 MHz.
The PL-PLUS’ voltmeter has a basic accuracy of +/- 2 volts, (extreme cold or heat may cause an additional one volt of error). Should the voltage reading ever become inaccurate, it can be easily recalibrated by a qualified service technician.
The Classic Series features Furman’s revolutionary Series Multi-Stage Protection (SMP), Linear Filtering Technology (LiFT), and Extreme Voltage Shutdown (EVS). Together, these technologies comprise what is, without question, one of the world's most advanced and comprehensive transient voltage surge supressors.
Can't track down where that noise is coming from? Your mix sounding flat? With Furman's advanced Linear Filtering Technology you'll lower the noise floor caused by the dirty AC power coming into your console or DAW. Furman's advanced advanced Series Multi-Stage Protection keeps your sensitive digital equipment from acting funny or burning up due to everyday spikes and surges. With a 15A capacity and eleven total outlets, it's enough to power your whole home studio.
- Features
Features
- Surge Protection
- Noise Filtration
- Voltage Protection
- Pull-out Lights
- Diagnostic Lights
- LED Voltmeter
- Isolated Banks
- Wall Wart Spacing
- 15 AMP Rating
- Nine Total Outlets
- BNC Lamp Connector
- Specification
Maximum Output Current 15 amps Pull-out Lights Two multi-LED, dimmable lamps Line Cord Captive 3/14 AWG, 10 ft black cord BNC Socket with Switch 12VAC 500MA maxx Operating Voltage 90 to 139 VAC Spike Clamping Voltage 188 VAC peak @ 3,000 Amps Response Time 1 nanosecond Maximum Surge Current 6,500 Amps Noise Attenuation 10 dB @ 10 kHz, 40 dB @ 100 kHz Power Consumption 12W Dimensions (H x W x D) 1.75" (44.5 mm) x 19" (483 mm) x 10.5" (266.7 mm) Weight 12 lbs (5.44 kg) - Documents
Documents
- Reviews
Write Your Own Review