The PZM185 Pressure Zone Microphone is a microphone designed for general-purpose use. Ideal for applications such as conferences, group discussions, interviews, broadcast, home video production, lectures, and recordings. The mic can be placed on a large surface such as a table, floor, wall, or lectern. The PZM185 is powered either by an internal AAA 1.5V battery or 12 48V phantom power. The boundary "paddle" can be detached so the mic will fit in your pocket. Attached to the mic is an 8-foot (2.438-m) cable leading to a tubular power module. The microphone’s low profile design reduces "mic fright" and minimizes clutter. It is nearly invisible on camera. The PZM-185 minimizes pickup of vibration and handling noise. Its electret condenser capsule provides a wide, smooth frequency response from 50 Hz to 16 kHz.
The mic's hemispherical polar pattern allows clear pickup of everyone surrounding the microphone. The PZM185 is protected against static and RFI. The output is balanced, low impedance, which allows long cable runs without hum pickup or high-frequency loss. Like other Pressure Zone Microphones, the PZM185 uses a miniature mic capsule mounted very near a sound-reflecting plate or boundary in the Pressure Zone. In this zone, direct sound from the sound source combines in phase at all frequencies with reflected sound off the boundary. The benefits are many: 6 dB more sensitivity, 6 dB less noise, a wide smooth frequency response free of phase interference, excellent clarity and "reach," and consistent pickup anywhere around the microphone.
| Frequency Response (typical) | 50 Hz to 16 kHz |
|---|---|
| Polar Pattern | Hemispherical (half-omni) on a large surface |
| Impedance | 150 ohms, balanced. Recommended minimum load impedance 1000 ohms |
| Open Circuit Sensitivity (1.5V battery power) | 0.8mV/Pa (–62 dB re 1 volt/Pa) |
| Power Sensitivity (1.5V battery power) | –59.5 dBm. EIA sensitivity –154 dBm |
| Open-Circuit Sensitivity (phantom power) | 3.2 mV/Pa (–50 dB re 1V/Pa) |
| Power Sensitivity (phantom power) | –47.5 dBm. EIA sensitivity –142 dBm |
| Equivalent Noise Level (self-noise) | 21 dB SPL typical, A-weighted (0 dB = .0002 dyne/cm2) |
| S/N Ratio | 73 dB at 94 dB SPL |
| Maximum SPL | 120 dB SPL produces 3% distortion with phantom power |
| Polarity | Positive pressure on the diaphragm produces positive voltage on pin 2 |
| Cable | 8-foot (2.438-m), 2-conductor shielded, permanently attached cable. No other cable supplied |
| Output Connector | 3-pin XLR-type pro audio connector |
| Operating Voltage | One 1.5V size AAA alkaline battery (Duracell MN2400 or equivalent) or 12 to 48V phantom power |
| Battery Life | Approximately 45 days |
| Current Drain | 0.5 mA |
| Materials | High-impact plastic housing and steel power module |
| Finish | Satin Battery |
| Included Accessory | 1.5V AAA battery |
| Dimensions (H x W x D) | 0.74" (19 mm) x 3.43" (87 mm) x 5.9" (150 mm) |
| Weight | 0.253 lbs (115 g) |
Usually arrives in 5-9 business days.
