The electret condenser microphone is a very low profile boundary layer microphone with an omni-directional polar pattern. The microphone is constructed of brass and includes 9.9 ft of screened cable. The Microphone includes a separate inline Phantom Power Adaptor which is to be powered by 9 to 48 volts. The in-line adaptor also includes filters which will eliminate all GSM frequencies from 800-1200 MHz. Impedance 200 Ohms @ 1KHz, frequency response 50 Hz to 18 KHz +/-3dB, sensitivity -47dB +/- 3dB @ 1Khz (0dB =1V/Pa), total Harmonic Distortion (THD) at an operating level of 120dB less than 1%. The Microphone includes 4 small rubber isolation feet to help minimize the transfer of mechanical noise and vibrations from the table. The Microphone has a non-reflective Gray Nextel® finish.

• Boundary layer condenser microphone
• RF friendly technology offering immunity from GSM (cellphones) and other sources of frequency interference
• Omni-directional polar pattern
• Wide range smooth response
• Very low profile
• Supplied with a separate in-line phantom power adaptor
• Finish: gray Nextel
• Also available in Nextel suede coating finishes (custom orders only)

Cut Sheet

Line Drawing