The condenser microphone is a through desk/ceiling/panel mount boundary layer type with an omni-directional polar pattern. The microphone is made from a robust high-quality brass construction with low profile brass top. It is terminated with a male 3 Pin XLR. The microphone is fitted with an integral Phantom Power Module accepting 9 to 48 volts DC. The Phantom Power Module also includes filters which will eliminate all GSM frequencies from 800 - 1200 GHz. Frequency response 50 Hz to 20 KHz; Sensitivity -42dB +/- 3dB @ 1Khz (0dB=1V/Pa) Impedance 200 Ohms. Total Harmonic Distortion (THD) at an operating level of 120dB is no greater than 1%. Included are rubber isolators to minimize the transfer of mechanical noise from table, ceiling or panel. Finish: Nickel.

• RF friendly technology offering immunity from GSM (cellphones) and other sources of frequency interference
• Engineered in high-quality brass
• Omni-directional polar pattern
• Wide smooth response
• Balanced output
• Simple through-desk shock mounting
• Low profile at surface level
• Integral phantom power module
• Finish: nickel
• Also available in Nextel suede coating finishes (custom orders only)

Cut Sheet

Line Drawing

Installation Guide