The condenser microphone design is for a through desk/ceiling/panel mount boundary layer type with a cardioid polar pattern. The microphone is made of a robust high-quality brass construction with a low profile robust brass top. It is terminated with a male 3 pin XLR. The microphone is powered by a 9 to 48 volts phantom power adaptor which also includes filters that will eliminate all GSM frequencies from 800 - 1200 MHz. Frequency response 50 Hz to 18 KHz; Sensitivity -37dB +/- 3dB @ 1Khz (0dB=1V/Pa) Impedance 200 Ohms. Total harmonic distortion (THD) at an operating level of 120dB is no greater than 1%. Also included are rubber shock mounts to minimize the transfer of mechanical noise from table, ceiling or panel. Length 90.00mm (3.55"). Finish: Nickel.

• RF friendly technology offering immunity from GSM (cellphones) and other sources of frequency interference
• Engineered in high-quality brass
• Cardioid polar pattern
• Wide smooth response
• Balanced output
• Simple through-desk shock mounting
• Low profile at surface level
• Inbuilt phantom power module
• Finish: nickel
• Also available in Nextel suede coating finishes (custom orders only)

Cut Sheet

Line Drawing

Installation Guide