Volume Controls

The Ashly WR-1 is an assignable, dual potentiometer remote volume control for the controlled product. Each volume control is connected to a euroblock jack terminal on the WR-1 circuit board, which in turn must be wired to the 24.24M back panel euroblock connector labeled "0 - 5 Volt Remote Level Control".

The Ashly WR-2 Multi-Function Wall Network Remote Volume Control allows selection of one of four presets via interlocking pushbutton switches. Each pushbutton switch connects to a euroblock on the rear of the controlled product.

The Ashly WR-1.5 volume control fits in standard wall boxes and used low gauge wire for hook-up. It has a single potentiometer for remote level control, plus a 4-position rotary switch for preset recall. The remote level control uses DC voltage provided by the host unit to attenuate one channel of that unit.

Control your system from any location with the Ashly WR-5 Programmable Multi-Function Decora Wall Remote Control. This device fits in standard wall boxes and uses low gauge wire for hook-up. WR-5 is a programmable remote button controller for Ashly amps and processors that have a serial data connector.

Control your system from any location with this Network Enabled remote control. The neWR-5 is a programmable remote button controller for Ashly Network Enabled amps and processors.

Control your system from any location with this wall-mountable RRW-8C wall-mountable programmable remote fader controller for Ashly amps and processors that have DSP and a serial data connector.

The Ashly FR-8 8-channel DSP network remote fader is a great choice for facilities that use amateur operators for occasional live performances. Mix and match network remotes in a single installation via a standard Cat-5 cable.