- Description
Details
The high-tech enclosure uses injection-molded high-impact polypropylene to make the ZX1i extremely durable. The enclosure geometry has been engineered to provide maximum rigidity and acoustic performance. The velocity compensated port design overcomes the limitation of many small cabinet loudspeakers and enables exceptional low-frequency response without vent noise.
ZX1i installation is incredibly simple with the included QuickSAM mounting system. The QuickSAM is a unique, integrated mounting bracket which is virtually foolproof. It allows the installer to simply snap the speaker onto the bracket, then tighten it to the desired position. For array mounting, there is an optional array bracket kit available which allows multiple units to be mounted together for a variety of configurations.
Zx1i uses a special circuit that when in transformer mode the network re-configures itself to a current actuated Hi-Pass filter at the transformer primary. It gently rolls off the lowest frequencies to maintain a safe load on the amplifier without affecting the higher (vocal) frequencies and the program continues without interruption. Low frequency current is limited through the transformer eliminating low frequency saturation. Automatic Saturation Compensation allows many speakers to be run on a distributed line with a 50Hz Hi-Pass filter before the amplifier, regardless of the number of speakers on the same line (the number of tapped watts cannot exceed the amplifier rating). With the same 50Hz Hi-Pass, 10 speakers on transformers will have the same full sound as a single speaker at 8 ohms.- Features
Features
- Patented ASC (Automatic Saturation Compensation)
- Available in 70/100 volt transformer version
- Integrated QuickSAM heavy-duty Strong-Arm Mounting bracket
- EN54-24 type B certification 1438/CPD/0323 with TC-ZX1i cover (Sold separately) installed (only available in select regions)
- Specification
Frequency Range (-10 dB) 48 Hz - 20 kHz Frequency Response (-3 dB) 60 Hz - 20 kHz Axial Sensitivity 92 dB (1W/1m) Max Calculated SPL 121 dB Rec. Hipass Frequency 40 Hz Horizontal x Vertical Coverage 100° x 100° Rated System Power 200W Cont.², 400W Prog., 800W Peak LF Transducer EV8L, 8 in (203mm) Driver HF Transducer DH2005, 1 in. (25.4mm) Exit Compression Driver Crossover Frequency 1.7 kHz Nominal Impedance 8 Ohms Minimum Impedance 6 Ohms Connectors 4-Pin Phoenix Connector Enclosure Material High Impact Polymer Suspension Integrated QuickSAM Heavy-Duty Strong-Arm Mounting Bracket Grille Polyester Powder Coated, 18GA Galvanized Steel Dimensions (H x W x D) 17.75" (451 mm) x 11.12" (282 mm) x 10.35" (263 mm) Net Weight (Without Transformer) 8.4 kg (18.5 lbs) Shipping Weight (Without Transformer) 10.2 kg (22.5 lbs) Without Transformer - Reviews
Write Your Own Review