The first high-gain amplifier to deliver pristine cleans, the Peavey invective™.120 starts with the no-compromise high-gain performance of the legendary Peavey 6505® series, then adds a level of versatility that is unprecedented in an amp within this class. Designed in collaboration with Misha Mansoor of Periphery, the invective.120 features three channels which each deliver a distinctive sonic-range, as well as a long list of controls which allow you to dial in that perfect tone. Use the included footswitch to quickly switch from one tone to the next, from the most extreme high gain metal, to a flawless classic rock tone, to a deep clean jazz tone - it's all there, and everything in-between!
A tube amp only sounds as good as what's inside, and Peavey's invective.120 delivers with four matched JJ6L6GC output tubes with top-loaded bias test points and adjustment. The rear panel features paralleled speaker outputs with impedance selector, an MSDI-XLR direct output with Level/Tone/Ground Lift, MIDI out/thru, and MIDI footswitch input. The included footswitch has nine presets to further help the player achieve their desired tone. Two remote switchable effects loops, half-power switch, and two 9VDC/ 500mA auxiliary power jacks for effects pedals complete the rear panel.
On the front panel, players will find even more options and advanced control. The invective.120 Head has a single input with three key remote switchable channels (Clean/Crunch/Lead), giving you a sonic palette that lets your imagination run wild. Both the Lead and Crunch channels have independent Pre and Post Gain controls as well as shared low/mid/high EQ, in line with the revered Peavey 6505® head. They also feature a shared switchable front end boost fast attack input noise gate with a threshold for complete control over muting. The standby and power switches with blue jeweled pilot light indicate when the amp is ready. Just adjust the Master Resonance, Presence and Volume knobs, and it's ready to rock.
| Amplifier Rated Power & Load | 120W (rms) into 16, 8, or 4 Ohms |
|---|---|
| Power @ Clipping | (Typically @ 5% THD, 1kHz, 120VAC line) 130W(rms) into 16, 8, or 4 Ohms (Bias must be reduced to measure) |
| Frequency Response | +0, -3dB, 50Hz to 20kHz, @ 100W (rms) into 8 Ohms |
| Hum & Noise | Greater than 78dB below rated power |
| Power Amp EQ | Active Presence: +10dB @ 2kHz Active Resonance: +10dB @ cabinet resonant frequency |
| Dimensions (H x W x D) | 10" (254 mm) x 26.7" (678 mm) x 11.8" (300 mm) |
| Weight | 48.39 lbs (21.95 kg) |
| Shipping Weight | 57.54 lbs (26.1 kg) |
Usually arrives in 5-9 business days.
