The IP™-SIX is a dual-channel Amplifier. 400 watts RMS/channel (2 ohms) and 300 watts RMS/channel (4 ohms). Bridge mode operation (800 watts, 4 ohms) and bridge mode opearation (600 watts @ 70 volts). Exclusive SPS speaker protection circuitry. Variable-speed fan and hibernation circuitry. IP-Six amplifiers are two rack space units of 13.5" (343 mm) depth that mount in a standard 19" rack. On all amplifiers, four front-panel mounting holes are provided. Rear-mounting ears are also provided on all amplifiers for additional support. Distance from the back of the front-rack ear to the center of the rear-mounting ear holes is 13 1/8" (333 mm).
| Rated Power 4 ohms bridge | 825 watts @ 1 kHz |
|---|---|
| Rated Power 8 ohms bridge/70 volts | 612 watts @ 1 kHz Sine Wave |
| Program Power 8 ohms bridge/70 volts | 800 watts |
| Rated Power 2 x 2 ohms | 400 watts per channel @ 1 kHz |
| Rated Power 2 x 4 ohms | 300 watts per channel @ 1 kHz |
| Rated Power 2 x 8 ohms | 180 watts per channel @ 1 kHz |
| Rated Power 1 x 2 ohms | 500 watts @ 1 kHz at |
| Rated Power 1 x 4 ohms | 350 watts @ 1 kHz at |
| Rated Power 1 x 8 ohms | 200 watts @ 1 kHz at |
| Minimum Load Impedance | 2 ohms |
| Maximum RMS Voltage Swing | 45 volts |
| Frequency Response | 10 Hz - 25 kHz; +0, -1 dB at 1 watt |
| Power Bandwidth | 10 Hz - 50 kHz; +0, -3 dB at rated 2 ohm power |
| T.H.D. 2 x 2 ohms | < 0.10% @ 325 W per channel from 20 Hz to 20 kHz |
| T.H.D. 2 x 4 ohms | < 0.10% @ 250 W per channel from 20 Hz to 20 kHz |
| T.H.D. 2 x 8 ohms | < 0.10% @ 160 W per channel from 20 Hz to 20 kHz |
| SMPTE IMD | < 0.1% 60 Hz and 7 kHz, 250 W @ 4 ohms |
| Slew Rate | 7V/us |
| Damping Factor (8 ohms) | > 400:1 @ 20 Hz - 400 Hz |
| Input CMRR | > -97 dB @ 1 kHz |
| Voltage Gain | x 40 (32 dB) |
| Input Sensitivity | 0.728 V @ 2 ohms, 0.854 V @ 4 ohms, 0.952 V @ 8 ohms |
| Input Impedance | 15k ohms, balanced |
| Hum and Noise | > -110dB, “A” weighted referenced to rated 4 ohm power |
| Crosstalk | > -70dB, “A” weighted referenced to rated 4 ohm power |
| Current Draw @ 1/8 power | 465 watts @ 2 ohms, 320 watts @ 4 ohms, 210 watts @ 8 ohms |
| Current Draw @ 1/3 power | 996 watts @ 2 ohms, 683 watts @ 4 ohms, 396 watts @ 8 ohms |
| Idle Current Draw | 30 watts |
| Max. Current Draw | 1752 watts @ 2 ohms, 1158 watts @ 4 ohms, 710 watts @ 8 ohms |
| Cooling | 80 mm DC fan, off until heat sinks reach 45°C, then variable speed |
| Controls | 2 rear panel attenuators |
| Indicator LEDs | 2 Clip, 2 Status |
| Protection | Temp, DC, turn-on transients, improper load or shorts |
| Connectors | 8 pin plugable signal input, 4 terminal barrier strip, IEC AC power connector |
| Construction | 18 ga. steel reinforced with 12 ga. rack ears |
| Unit Weight | 23.0 lbs (10.43 kg) |
| Packaged Weight | 28.3 lbs (12.84 kg) |
| Dimensions | 88.4mmx483mmx347.7mm, 342.9mm Behind Rear Mounting Ears (3.48"x19"x13.688", 13.5" Behind Rack Ears) |
Usually arrives in 5-9 business days.
Usually arrives in 5-9 business days.
Usually arrives in 5-9 business days.
Usually arrives in 5-9 business days.
Usually arrives in 5-9 business days.
