The multi-channel ne (Networked-Enabled) Series Amplifiers are uniquely designed around an energy efficient Class-D platform with a switching power supply.

This eight-channel power amplifier delivers a minimum power of 150 Watts RMS per channel into 8 Ohm loads and 250 Watts RMS per channel into 4 Ohm loads with all channels operating. When switched into bridged-mono mode, channels 1+2 or 3+4 or 5+6 or 7+8 of the amplifier delivers at least 500 Watts RMS into an 8 Ohm load. The power amplifier includes Euroblock input connectors, Euroblock output connectors, and balanced analog inputs. The power amplifier has remote standby for power up, DC remote level control and contact closure preset recall. It shall have Ethernet control and monitoring of power functions, level, mute, polarity, temperature, current, and amplifier fault conditions. Frequency response is 20Hz to 20kHz ±1.0dB. Signal-to-Noise is greater than 105dB unweighted and SMPTE intermodulation distortion shall be less than 0.5% into an 8 Ohm load, 10dB below rated output. The front panel provides the status of power, standby, protect, power switch disable, signal level, bridge, over-temperature, over-current, and Ethernet communication. The power amplifier is capable of having factory installed AES3, CobraNet®, or Dante® interface options with the addition of two 4-Channel DAC cards.

• 10/100 Ethernet comes standard for remote control and monitoring
• Low-Z, 25V, 70V, 100V models
• AES3, CobraNet® and Dante® input options
• DC voltage remote gain control
• Switched-mode power supply, Class-D output
• Stepped, calibrated input attenuators
• Remote power standby
• Disable all front panel controls via software
• Temperature sensitive variable speed fan with side-to-front airflow
• Selectable HPF frequencies (80Hz, 400Hz, off) on 25V, 70V, and 100V models
• 4-stage level meters
• Output current and temp indicators
• Safety/Compliance: cTUVus, CE, FCC, RoHS

Data Sheet

Manual