- Description
Details
Bogen's V150 Power Vector Modular Amplifier offers 150 Watts of power and is designed to work with both high- (70/25V) and low- (4/8-ohm) impedance speaker systems. The model includes eight module bays for plug-in input modules and allows up to four levels of priority between modules. Two module bays are capable of accepting plug-in signal-processing output modules. Each module is controlled by an independent volume control with an associated signal/clip LED for signal status. An 11-segment LED output meter monitors output signal level. It also includes a motorized master volume control that can be controlled using a remote volume control panel (RVCP, sold separately).- Features
Features
- Capable of handling 70V, 25V, 8-ohm, and 4-ohm speaker loads
- 8 module bays
- Wide selection of advanced plug-in modules
- 4 levels of priority between modules
- 2 module bays capable of handling plug-in signal-processing output modules
- 11-segment LED output level meter monitors the output level of the power amplifier with Peak and Average meter switch
- Motorized master volume control can be remotely operated
- 5-position barrier strip, with clamping washers, provides connections for speaker loads
- Bridging In/Out connector
- External access to priority mute buses
- Bridging jack and Mute terminals join multiple Power Vector amps and mixers together
- Independent volume control for each of the eight module bays
- Specification
Power Output (RMS) Rated 150W Typical @ 1 kHz 200W Frequency Response Transformer 45 Hz to 20 kHz; +0/-2 dB Direct 20 Hz to 20 kHz; +0/-1 dB Distortion Transformer < 0.5%** Direct < 0.1%** (.05 typical @ 1 kHz) Signal-to-Noise   Fundamental -94 dB With SAX1R Module -70 dB With MIC1S Module -60 dB With TEL1S Module -70 dB Tone Controls Bass Frequency 100 Hz (+/- 10 dB minimum) Treble Frequency 10 kHz (+/- 10 dB minimum) Low Cut Frequency 125 Hz @ -6 dB/octave Sensitivity Output Regulation 0.4V (at backplane connector) 2 dB or better, no load to full load Output Impedance Transformer-Coupled 70V, 25V, 8 ohms (bal or unbal) Direct Coupled 4 ohms (minimum) Thermal Emissions (BTU/hr.) 696.7 Inserts Insert 1VRMS (@FRP) Insert 50 ohms maximum Insert 1VRMS Insert 10k ohms minimum Bridging In/Out Bus Level 250 mVRMS (@FRP) Bus Impedance 10k ohms maximum Pre-EQ Output Output Level 4VRMS (@FRP) Output Impedance 50 ohms maximum AC Power Receptacle 500 watts maximum power, unswitched AC Voltage 120V AC, 60 Hz AC Current 3.5A Dimensions (H x W x D) 3.875" (98.425 mm) x 17.25" (438.15 mm) x 14.75" (374.65 mm) Weight 31 lbs (14.06 kg) - Reviews
Write Your Own Review