Search results for 'Williams Sound PPA'

The Yamaha DCP4V4S Digital Control Panel is used for the MTX Series and can be used with up to 8 controllers per 1MTX with CAT5 cable. It has a max cable length up to 200m.

When used in conjunction with the DM8000 Digital Audio Processor, the Klark Teknik CP8000UL provides easy control over volume and selection for up to 6 auxiliary inputs.

The TOA WP-700-AM is a wall remote control panel, designed to remotely control MA-725F (or MM-700F) matrix mixer amplifiers.

The Ashly WR-1 is an assignable, dual potentiometer remote volume control for the controlled product. Each volume control is connected to a euroblock jack terminal on the WR-1 circuit board, which in turn must be wired to the 24.24M back panel euroblock connector labeled "0 - 5 Volt Remote Level Control".

The Ashly WR-1.5 volume control fits in standard wall boxes and used low gauge wire for hook-up. It has a single potentiometer for remote level control, plus a 4-position rotary switch for preset recall. The remote level control uses DC voltage provided by the host unit to attenuate one channel of that unit.

The Audio Enhancement WPA-03 Wall Plate expands the features of the CA-30 Amplifier. It provides an audio input that the teacher can use with any multi-media device (i.e. IPod™, Laptop Computer, etc.).

Control your system from any location with the Ashly WR-5 Programmable Multi-Function Decora Wall Remote Control. This device fits in standard wall boxes and uses low gauge wire for hook-up. WR-5 is a programmable remote button controller for Ashly amps and processors that have a serial data connector.

Control your system from any location with this Network Enabled remote control. The neWR-5 is a programmable remote button controller for Ashly Network Enabled amps and processors.

The QSC MP-MFC controller is an intuitive wall mount control to enable customizable system adjustments for the MP-M Series music and paging mixer. Designers can configure these control peripherals to provide end users with as much or as little control over the system as needed.

The QSC MP-MFC controller is an intuitive wall mount control to enable customizable system adjustments for the MP-M Series music and paging mixer. Designers can configure these control peripherals to provide end users with as much or as little control over the system as needed.

The OWI MC4 will allow either line or mic level inputs on each channel. It has an additional four sets of level controls to provide a fixed secondary output not affected by any of the changes on the front panel level input controls.

Control your system from any location with this wall-mountable RRW-8C wall-mountable programmable remote fader controller for Ashly amps and processors that have DSP and a serial data connector.

The OWI MC4-BT is a Mic/Line audio mixer with a localized Bluetooth receiver and a manual volume control of Bluetooth signal.

The Biamp Tesira TEC-1i is an Ethernet control device for use with all Tesira systems. It offers a simple, intuitive interface for end users and can be installed and configured to fit the unique needs of a particular application.

The BSS Audio BLU-8v2 is a HiQnet compatible programmable zone controller capable of controlling a single zone, four zones or eight zones in different modes of operation. A simple control surface and informative visual feedback ensure that non-technical users can be confident in making changes to an integrated AV system.

The Lowell 50LVC-SA volume control is a 50W autoformer attenuator (volume control) with 3dB steps is for use with 100/70/25V or 8ohm speaker line (depending on model selected). Includes 1-gang standard wall plate with rotary knob. Wall plates are offered in variety of finishes. ETL Listed.